Euclid Probe 24V

The highly accurate, magnetically coupled Z-Probe that is not affected by bed temp, bed material, magnetism or surface treatment. Capable of operating up to 80C natively.

Euclid Probe uses screw attached magnets to a PCB for both mechanical coupling and for electrical contacts and dimensional accuracy. It is simply the most reliable and secure method for attaching the magnets to the parts. The Z-Probe circuit is completed when the probe is attached to the dock.

You can check the Teaching Tech Review here

Magnetic build plates with textured PEI, smooth glass, Buildtak, GeckoTek, Euclid can sense them all! Swap out build surfaces without fear of changing Z-Probe offsets. The probe can be configured to be used as both a standalone Z-probe or used as combination endstop and Z-Probe.

Works with all firmwares- Klipper, Duet2 & Duet3 running both RepRap 2.x and RepRap 3.x, Smoothie and even Marlin! The Probe can be manually deployed or automatically deployed via gcode macros and can take advantage of your firmware’s probe pickup detection scheme to ensure probe pickup and docking.

Note: This is a DIY kit, that requires assembly and some soldering. Please check here the Assembly Instructions

Included:
1x Omron SPDT Switch
2x Euclid PCB’s
2x Polarized Magnet Pairs in a convenient assembly holder
4x M2 Flathead Screws for magnet mounting
4x Low profile SMD nuts
1x JST-XH 3 position header, with matching female ferrules
1x Dupont 3 Position header, with matching female ferrules
2x M2.5 Tapping Screws for attaching the probe to 3D printed mounts.